Network Menu; Cellular Menu; Ip Camera - Bosch B6512 Installation Manual

122 en | Keypad Installer menu
20.3.2

[2] Network menu

Use the Network menu to view information about the control panel's network connection.
Settings
1.
2.
3.
Connection
1.
2.
3.
20.3.3

[3] Cellular menu

You can obtain certain cellular module diagnostic information using a keypad and this menu.
Cellular (diagnostics)
1.
2.
3.
20.3.4

[4] IP Camera

IP Camera
1.
2.
2017.04 | 15 | F.01U.287.180
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [3] Diagnostics Menu > [2] Network > (choose the bus module or on-board) > [1]
Settings. The keypad the following sub-categories, indicating the programming for: Host
Name:, IPv4 Source IP:, IPv4 Source IP:, MAC Addr:. (Use
necessary.)
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [3] Diagnostics Menu > [2] Network > (choose the bus module or on-board) > [2]
Connection.The keypad scrolls through the following sub-categories, indicating the
connection status for: Link, IP Address, DNS, LAN, WAN. (Use
if necessary.)
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [3] Diagnostics Menu > [3] Cellular > (choose the SDI2 cellular module or plug-in
module). The keypad scrolls through the following sub-categories, indicating the
diagnostic information. (Use
– Link (Yes or No. Yes indicates a data connection to the carrier. No indicates a
connection problem.)
– IPv4 IP (The IP address of the cellular radio on the carrier's network.)
– Base ID
– Signal (Signal strength = unacceptable, marginal, good, or very good.)
– Signal (In dBs.)
– Tel Num (If provided by the carrier.)
– ESN (The cellular radio electronic serial number.)
– Model (The cellular radio model.)
– Version (The cellular radio version.)
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [3] Diagnostics Menu > [4] IP Camera. The keypad shows one of the following
statuses:
– Not Configured
– Not Responding
– Bad Password
– Online
– Missing
/Next to scroll through, if necessary.)
Installation Manual
Control Panels
/Next to scroll through, if
/Next to scroll through,
Bosch Security Systems, Inc.