How To Measure Automatically - Owon SDS6062 User Manual

Note:
1. When Pass/Fail is ON , if XY or FFT is ready to run ,then Pass/Fail will be closed;
under the mode of XY or FFT , Pass/Fail is unable.
2. Under the mode of Factory , Auto Scale and Auto Set , Pass/Fail will be closed.
3. When no save setting left in the rule save, tip will be given to show "NO RULE
SAVED".
4. Under the status of stop, data comparing will stop, and when it goes on running,
the number of Pass/Fail will increase from the former number, not from zero.
● Output
Press the Utility button and turn the M to select the Output to go to the following
menu.
The description of Output menu is shown as the follows:
Function
Setting
Menu
Trig level
Type
Pass/fail

How to Measure Automatically

Press the Measure button to display the menu for the settings of the Automatic
Measurements.
User Manual of Smart Digital Storage Oscilloscope
Fig.5-44 Pass/Fail test
Fig.5-45 Output menu
Description
Output trig signal synchronously
Output High Level when Pass , and Low Level when Fail
5. Advanced User Guidebook
58