Exchange Of Flowmeter - MIB Flowmax 44i Operating Manual


Flowmax 44i

4. Exchange of flowmeter


Switch off power before disconnecting the electrical connections!

Wiring installation, disassembly and removal must be performed
by qualified persons experienced and knowledgeable about
electrical work.

Serious injury or death from electric shock may occur if wiring,
installation, disassembly or remove of wires is performed while
electrical power is energized

Please note that after replacing the flowmeter
a) Specific programming of the previous flowmeter should be noted and
programmed to the new flowmeter
b) when using the dosing function, set a quantity
If the device requires a configuration change, the display and programming unit
FlowCon 200i may be required (see section 6. Accessories).
Repair, hazardous substances
Before sending the flowmeter Flowmax 44i for repair, the following precautions
must be taken:

Clean all process chemicals from the device. Fully rinse the flow path.
Please pay close attention to the process fittings. All media must be
removed before returning. This is particularly important, if the medium
to be measured is health hazardous.
Devices judged to be insufficiently cleaned will be returned to sender. No
inspection of device will be done until proper cleaning is completed by user.
Costs due to inadequate cleaning of the instrument for possible disposal or
injury (burns, etc.) will be charged to the sender of the flowmeter into account.

With the flowmeter send a detailed report describing the failure, the
application and the physical-chemical properties of the medium
parameters. (e.g. a decontamination declaration).
In order to be able to process your repair order quickly and smoothly it is
important that you provide a technical contact person including phone and fax
number as well as e-mail address.
M I B
4. Exchange of flowmeter
WARNING!
WARNING!
WARNING!
31