Fine-Tune Scanning Position (Function Code: 54) - Brother ADS-2600W Service Manual

1.3.10 Fine-tune scanning position (function code: 54)

<Function>
This function is used to adjust the scanning start/end positions.
<Operating Procedure>
(1) Press the [5], and then the [4] key in the initial state of maintenance mode.
"SCAN ADJ SELECT" is displayed on the LCD.
After two seconds, "SUB" is displayed on the LCD.
(2) To adjust the sub scanning, press the [
press the [SET] key.
To adjust the main scanning, press the [
and press the [SET] key.
To adjust the skew scanning, press the [
and press the [SET] key.
(3) " : FRONT
Press [ ] key to adjust the first side.
Press [ ] key to adjust the second side.
(4) Press the [
[ ] key to adjust it in the negative direction.
(Compensation levels for sub scanning can be adjusted in 101 levels from +50 to -50.)
(Compensation levels for main scanning can be adjusted in 61 levels from +30 to -30.)
(Compensation levels for skew scanning can be adjusted in 41 levels from +20 to -20.)
(5) When adjusting is completed, press the [SET] key. "Accepted" is displayed on the LCD,
and the machine returns to the initial state of maintenance mode.
: BACK" is displayed on the LCD.
] key to adjust the compensation level in the positive direction or press the
Sub scanning First side
Main scanning
] or [ ] key to display "SUB" on the LCD, and
] or [ ] key to display "MAIN" on the LCD,
] or [ ] key to display "SKEW" on the LCD,
5-12
Second side
Confidential