Brother ADS-2600W Service Manual page 10

Federal Communications Commission (FCC) Declaration of Conformity

(USA only)
Responsible Party:
declares, that the product
Product name: ADS-2500W/2500WE
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
• This transmitter must not be co-located or operated in conjunction with any other antenna
or transmitter.
Important
• Changes or modifications not expressly approved by Brother Industries, Ltd. could
void the user's authority to operate the equipment.
• A specific shielded interface cable should be used to ensure compliance with the
limits for a Class B digital device.
Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807 USA
Tel: (908) 704-1700
vii
Confidential