Checking Operation After Repair - Brother ADS-2600W Service Manual

1.7

Checking Operation after Repair

Perform the steps below to check the machine's condition after repair or adjustment.
(1) Prepare two DS-001 (LD1625001) test charts and set them to the document tray so that
both sides of the test chart can be scanned.
(2) Press and hold the
ready state.
(3) Press the blank field at the bottom.
(4) Press the [*], [2], [8], [6], and [4] keys on the LCD in this order to enter the maintenance
mode.
(5) Connect the machine to your computer using the USB cable.
(6) Start the PaperPort.
(7) Select the Desktop tag and click the
[Select] button.
(8) Select "TW-Maintenance USB" and
click the [OK] button.
(9) When the screen shown on the right
appears during the scanning, choose:
Resolution: 600 dpi
Scan Type: 24bit Color
Document Size: Letter
and press the [Start] button to start
scanning.
key for approximately five seconds while the machine is in the
4-7
Confidential