Brother ADS-2600W Service Manual page 117

1.6 Setting Double Feeding Sensor Threshold
(1) Connect the machine to your computer using the USB cable in the initial state of
maintenance mode.
(2) Double-click "BrADSmt1.exe" that was saved into the computer to start it.
(3) Select the model name in the [Select model:] box, and click the [Start] button. The
double feeding sensor threshold is reset.
(4) After the following screen is appeared, set the sheet for double feeding sensor threshold
setting in the ADF, and execute the maintenance mode function "Check ADF".
Refer to "1.3.2 ADF performance test (function code: 08)" in Chapter 5.
(5) Execute the maintenance mode function "Acquire white level data and set CIS scan
area".
Refer to "1.3.11 Acquire white level data and set CIS scan area (function code: 55)" in
Chapter 5.
(6) Click the [Yes] button on the screen of step (4). The double feeding sensor threshold is
calculated and stored in the EEPROM of the main PCB.
When the setting is completed normally, "OK" is displayed on the screen.
If any error is detected during setting, "ERROR" is displayed on the screen.
(7) Unplug the AC power cord of the machine.
4-6
Confidential