Table of Contents
Advertisement
SuperWorkstation 7039A-I User's Manual
Installing a 3.5" Device
The SC732D3-1200B chassis has one 3.5" device slot, which supports an optional device
such as an all-in-one card reader.
Begin by removing power from the system as described in section 3.1.
Installing a 3.5" Device
1. Remove the front bezel from the chassis by lifting it upwards from the bottom, and
pulling off the front of the chassis.
2. Remove the cover plate from the 3.5" device slot on the front of the chassis.
3. Install the bracket rail (A) onto one side of the 3.5" device, by inserting the pins of the
bracket into the mounting holes on the sides of the optical device.
4. Slide the 3.5" device into the chassis.
Note: Enterprise level hard disk drives are recommended for use in Supermicro chassis and
servers. For information on recommended HDDs, visit the Supermicro website at
supermicro.com/products/nfo/files/storage/SBB-HDDCompList.pdf
Bracket
3
Rail (A)
Figure 3-11. Installing a 3.5" Device
34
Remove
Cover Plate
2
1
4
http://www.
Advertisement
Table of Contents
