Table of Contents
Advertisement
SuperWorkstation SYS-5039A-i User's Manual
Installing an Optional Device
The system supports a 3.5" optional device, such as an all-in-one card reader.
Installing a 3.5" Device
1. Remove power from the system as described in section 3.1.
2. Remove the front bezel from the chassis by lifting it upwards from the bottom, and
pulling off the front of the chassis.
3. Remove the cover plate from the bezel.
4. Install the bracket rail (A) onto one side of the device, by inserting the pins of the
bracket into the mounting holes on the sides of the device.
5. Slide the device into the chassis.
Bracket
4
Rail (A)
Figure 3-12. Installing a 3.5" Device
34
Remove
Cover Plate
3
2
5
Advertisement
Table of Contents
