Removing The Processor Heatsink Module (Phm) - Supermicro SuperWorkstation 7039A-I User Manual

SuperWorkstation 7039A-I User's Manual
Triangle on the CPU
Triangle on the
Processor Clip

Removing the Processor Heatsink Module (PHM)

Before removing the processor heatsink module (PHM), unplug power cord from the power
outlet.
1. Using a T30 Torx-bit screwdriver, turn the screws on the PHM counterclockwise to
loosen them from the socket, starting with screw marked #4 (in the sequence of 4, 3, 2,
1).
2. After all four screws are removed, wiggle the PHM gently and pull it up to remove it
from the socket.
Note: To properly remove the processor heatsink module, be sure to loosen and remove the
screws on the PHM in the sequence of 4, 3, 2, 1 as shown below.
Non-Fabric CPU and Processor Clip
(Upside Down)
d
D
Heatsink
(Upside Down)
D
On Locations (A, B), the notches
snap onto the heatsink's sides
Figure 3-3. Processor Heatsink Module (PHM)
b
c
B
a
C
A
On Locations of (C, D), the notches
snap onto the heat sink's
B
mounting holes
C
A
Make sure Mounting
Notches snap into place
22
Note: Your heatsink
will look different (1U
heatsink shown.)