Removing Hard Drives From The Carriers; Hard Drives - Supermicro SuperWorkstation 7039A-I User Manual

SuperWorkstation 7039A-I User's Manual

Removing Hard Drives from the Carriers

Installing an Optional Device
Begin by removing power from the system as described in section 3.1 and remove the chassis
cover as described in section 3.2.
1. If a hard drive is already present, remove it by carefully pulling the sides of the hard
drive carrier outward.
2. Remove the hard drive from the hard drive carrier.
3. Insert the new hard drive into the hard drive carrier.
4. Insert the hard drive carrier into the hard drive cage, sliding it towards the back of the
the hard drive cage until it clicks into a locked position.
5. If desired, each hard drive carrier may be secured to the exterior of the hard drive cage
using one optional screw.
6. Rotate the hard drive cage 90 degrees inward, returning it to the closed, operational
position in the chassis.
Figure 3-9. Removing a 3.5" Hard Drive from a Drive Carrier

2.5" Hard Drives

2.5" SATA drives may be installed into the chassis (using an optional HDD cage: p/n MCP-
220-73201-0N).The SC732D3-1200B chassis must be powered-down before hard drives can
be removed from the hard drive carriers.
Removing and Installing 2.5" Hard Drives
Begin by removing power from the system as described in section 3.1 and remove the chassis
cover as described in section 3.2.
1. Disconnect the chassis from any power source.
2. Loosen the thumb screw securing the 2.5" hard drive cage to the chassis.
3. Disconnect all cables from the hard drive.
1
1
32