Starter Relay - Yamaha WaveRunner FX SHO Service Manual

– +
ELEC
a
Starting system
8
7
6
5
4
3
2
1
1
R
Checking steps:
1. Connect the tester leads to the main and
fuel pump relay terminals 7 and 8.
2. Connect the positive battery lead to the
main and fuel pump relay terminal 6.
3. Connect the negative battery lead to the
main and fuel pump relay terminal 4.
4. Check the continuity between the termi-
nals 7 and 8.
Fuel pump relay continuity:
Battery lead
6 – 4
Disconnected
Connected

Starter relay

1. Measure:
• Starter relay input voltage
Out of specification → Check the wiring
harness.
Measurement steps:
1. Slide the boot away from the starter relay
terminal 1.
NOTE:
The positive battery cable is marked with gray
tape a.
2. Measure the input voltage between the
starter relay terminal 1 and ground.
Starter relay input voltage:
Red (R) – Ground
12 V (battery voltage)
7-51
E
Terminal 7 –
Terminal 8
No continuity
Continuity