Right Multifunction Display (Fx Cruiser Sho) - Yamaha WaveRunner FX SHO Service Manual

GEN
INFO

Right multifunction display (FX Cruiser SHO)

The display mode of the right multifunction display changes in the following order each time the
"Mode/Reset" button is pushed briefly.
Compass → Average speed → Tripmeter → Trip timer → Fuel consumption per hour → Fuel con-
sumption per kilometer/mile → Water temperature → Air temperature
To switch the display units between kilometers and miles, push the "Volt/Hour" button for at least 1
second, within 10 seconds after the multifunction meter starts operating.
Feature and benefit
1
1. Compass
This display shows the cur-
rent direction of the water-
craft using the 8 major
compass points.
2. Average speed
This display shows the
average speed in miles per
hour "AV MPH" or kilome-
ters per hour "AV KMH"
since it was reset.
3. Tripmeter
This display shows the dis-
tance traveled in miles
"MILES" or kilometers
"KM" since it was reset.
4. Trip timer
This display shows the
hours of operation
"TRIPTM" since it was
reset.
1 "Start/Stop" button
2 "Mode/Reset" button
2
1-35
5. Fuel consumption per
hour
This display shows the cur-
rent fuel consumption in
gallons per hour "G/HR" or
liters per hour "L/HR."
6. Fuel consumption per
kilometer/mile
This display shows the cur-
rent fuel consumption in
gallons per mile "G/MILE"
or liters per kilometer "L/
KM."
7. Water temperature
This display shows the
ambient water temperature
"L TEMP" (lake tempera-
ture).
8. Air temperature
This display shows the
ambient air temperature
"E TEMP" (environmental
temperature).
E