Yamaha WaveRunner FX SHO Service Manual page 91

CHK
ADJ
Control system
1
2
5
4
3
a
1
LT LT
572
3
4
STERN
2
b
3-8
2. Adjust:
• Shift cable joint (jet pump end)
Adjustment steps:
1. Set the shift lever to the reverse position.
2. Loosen the locknut 1.
3. Disconnect the shift cable joint 2 from the
ball joint 3.
4. Situate the reverse gate 4 to the stopper
5.
5. Turn the shift cable joint 2 in or out until
the specified distance a between the cen-
ter of the joint and the center of the ball
joint 3 is obtained.
WARNING
The shift cable joint must be screwed in
more than 8 mm (0.31 in) b.
Turn in Distance is decreased.
Turn out Distance is increased.
Distance a:
7 mm (0.28 in)
6. Connect the shift cable joint 2 to the ball
joint 3, and then tighten the locknut 1 to
the specified torque.
Locknut:
2.9 N·m (0.29 kgf·m, 2.1 ft·lb)
LOCTITE 572
E
1
2
3
4
5
6
7
8
9