Cruise Assist Control - Yamaha WaveRunner FX SHO Service Manual

GEN
INFO

Cruise assist control

The cruise assist has been added as a new function. The cruise assist is a function for maintaining
a set engine speed while cruising. Activation of the cruise assist will be confirmed by the beeper and
the digital speedometer display. The cruise assist can only be set between engine speeds of
approximately 3,000 r/min and approximately 7,000 r/min. The cruise assist cannot be activated in
the L-MODE.
To activate the cruise assist:
(1) Operate the throttle lever until the desired engine speed is reached.
(2) Once the engine speed reaches the desired cruise assist setting, push the "SET" switch.
When the cruise assist is activated, the beeper sounds 3 times quickly and the digital speedometer
display starts flashing. To keep the cruise assist activated, be sure to keep the throttle lever
squeezed further than the position at which the cruise assist was set.
Once the cruise assist is activated, the engine speed can be increased by pushing the up switch or
decreased by pushing the down switch. Each time a switch is pushed, the beeper will sound 1 time
quickly and the engine speed will change. However, the adjustment is limited to a maximum of five
increments above or below the initial cruise assist setting.
To deactivate the cruise assist:
Relax your grip on the throttle lever. The beeper sounds 2 times quickly and the digital speedometer
display stops flashing when the cruise assist is deactivated. The cruise assist is also deactivated
when the engine is stopped.
1 Up switch
2 Down switch
3 "SET" switch
Number of
Technical tips
1
2
3
Cruise assist operation
beeps
Engine speed increases or
Activated
Deactivated
decreases
1-43
Digital speedometer
display
Starts flashing
Stops flashing
Continues flashing
E