Yamaha WaveRunner FX SHO Service Manual page 149

POWR
Engine unit
e
A
f
l
n
d
A
g
j
A A
i
h
A A
k
m
5-24
38. Connect the APS coupler d, and the 8
multifunction meter, sensor, and switch
couplers e.
39. Install the engine cover f, and then
tighten the engine cover bolts g to the
specified torque.
NOTE:
Hold the engine cover down, and slide the
cover forward to install it.
Engine cover bolt:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
40. Install the shift cable bracket h, and then
tighten the shift cable bracket nuts i to
the specified torque.
Shift cable bracket nut:
16 N·m (1.6 kgf·m, 11.8 ft·lb)
41. Connect the shift cable joint j.
NOTE:
Apply grease to the shift cable joint and shift
cable.
42. Connect the positive battery cable k and
negative battery cable l to the battery.
NOTE:
After connecting the battery cables to the bat-
tery, coat the battery cable terminals and bat-
tery terminals with a water resistance grease
to minimize terminal corrosion.
43. Install the deck beam m and tighten the
deck beam nuts n to the specified torque.
Deck beam nut:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
E
1
2
3
4
5
6
7
8
9