Table of Contents
Advertisement
POWR
2
Camshaft
0
g
e
c
1
1280B
a
12. Turn the drive coupling 0 counterclock-
wise 2 turns.
NOTE:
Make sure that the camshafts turn smoothly. If
the camshafts do not turn smoothly, reinstall
camshafts. Refer to the installation steps.
13. Check that the portion g of the timing
chain is taut. If the timing chain is not taut,
turn the drive coupling slightly clockwise,
and then check that the timing chain is taut
again.
14. Position piston #1 at TDC.
Refer to "Camshaft removal."
15. Check that the punch marks c of the cam-
shaft are aligned with the alignment marks
e on the camshaft caps. If the punch
marks are not aligned, reinstall the cam-
shafts.
Cylinder head cover installation
1. Install:
• Cylinder head cover gasket 1
• Cylinder head cover 2
NOTE:
• Apply sealant onto the locations a of the
new cylinder head cover gasket 1.
• Tighten the cylinder head cover bolts in a
crisscross pattern.
Cylinder head cover bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
LOCTITE 572
5-63
E
Advertisement
Chapters
Table of Contents
