Unpacking And Setting Up - XYZ Printing Nobel Superfine User Manual

Product Overview and Accessories
●Front View
←Platform
Filling Tube→
Resin Bottle
Slot→
↑
Resin Tank
LCM→
←Operation
Panel
USB Disk
Port→

Unpacking and Setting Up

●Power On the Printer
Unpack the carton, remove all protective material
and take the printer out of the package.
Connect power adapter, power cord to the printer.
Switch on the printer.
■Back View
■Side View
●Raise the Platform
Select "UTILITIES" > "MOVE PLATFORM" > "TO
TOP" > "YES" to raise the platform.
Remove the protective materials under the platform.
The Nobel Superfine is shipped with the below parts and accessories. After unpacking, please
check if there is any damage on the printer and accessories. Please contact customer support
for any missing or defective parts and accessories.
■Warranty Card
●Back View
USB
Power
Cable
Jack↓ ↓
Port
●Side View
Power
Switch
↓
※Keep original packaging material in the event of
sending your unit back for repair.
●Install the Resin Bottle
Shake the resin bottle for about 10 seconds.
Assemble the nozzle cap and the inner tube, and
replace the original bottle cap with the assembled
one.
Put the bottle into the bottle slot. Install the filling
tubes (First, attach the black tube to the thick
nozzle. Then attach the transparent tube to the thin
nozzle and push all tubes down.)
Thick hole
■Quick Start Guide
■Power Cord
■Power Adapter
■USB Cable
■Scraper
Thin hole
■Rinse Basket
■Starter
Resin
■Gloves
■Inner Tube
■USB Flash Disk
Note
Before changing the resin bottle, remove the
transparent tube first, then remove the black tube.
●Refill Resin
Refill the resin tank before sending the printing task.
Please select "UTILITIES">"REFILL RESIN" on the
printer screen. And press and hold the UP key to
infuse resin into the tank. Release the UP key until
the resin reaching the "Max" mark on the resin
tank(The resin capacity to MAX mark on the resin
tank is about 90g), to avoid resin effluence from the
resin tank.
■Nozzle Cap
Up
-3-