Safety Notice - XYZ Printing Nobel Superfine User Manual

Hide thumbs Also See for Nobel Superfine:

Quick start manual (2 pages)

Table of Contents

● Error Code 2004: Lid not covered during printing

Suggestion:

Place the lid on the printer before printing. If the lid is placed correctly, please remove the lid, select "INFO">"SENSOR STATUS", tap the lid sensor and see if the status of

"C" switches from 0 to 1. If the value doesn't switch accordingly, then the sensor is malfunctioning. Contact the service center after you have checked the status of the

printer.

● Error Code 2005: Unrecognized resin tag

Suggestion:

Check the record of the resin bottle by selecting "INFO">"RESIN STATUS". If the display shows "UNIDENTIFIED TAG", please change to XYZprinting resin bottle.

● Error Code 2006: Unable to resolve the file

Suggestion:

Slice the file again with XYZware_Nobel. Be sure to set "Printer Type"as Nobel Superfine while slicing the file.

● Error Code 2007: File too large

Suggestion:

Please select a .3wn file, size no more than 200MB.

● Error Code 2008: Non-manifold issue is found in the file

Suggestion:

Repair the file with 3D model repairing software (such as netfabb or MakePrintable) and slice the model with XYZware_Nobel again.

● Error Code 2009: Resin tank is not installed correctly

Suggestion:

Confirm if the resin tank is installed correctly. If the resin tank is placed correctly, remove the tank, select "INFO">"SENSOR STATUS" on the printer, touch the resin tank

sensor, and see if the status of "T" switches from 0 to 1. If the value doesn't switch accordingly, then the sensor is malfunctioning. Contact the service center after you

have checked the status of the printer.

● Error Code 2020: Printer is busy

Suggestion:

Wait until the printer finishes current task. If the error persists when the printer is idle, please try to restart the printer.