XYZ Printing Nobel Superfine User Manual page 21

● Error Code 1003: NFC tag reader malfunctioned
Suggestion:
Contact customer service center directly.
● Error Code 1004: Engine board malfunctioned
Suggestion:
Contact customer service center directly.
● Error Code 1009: WIFI module malfunctioned
Suggestion:
Contact customer service center directly.
● Error Code 100A: Z axis motor malfunctioned
Suggestion:
Turn off the printer and confirm if the printing platform and the resin tank are installed correctly. If the error still occurs, contact customer service center.
● Error Code 100C: Internal error
Suggestion:
Contact customer service center directly.
● Error Code 100D: Internal error
Suggestion:
Contact customer service center directly.
● Error Code 100E: Internal error
Suggestion:
Contact customer service center directly.
● Error Code 1020: Printer not found
Suggestion:
Make sure printer is powered on, and connected to PC correctly. If the error persists, please try to restart your PC or refer to FAQ on XYZprinting website.
● Error Code 1021: XYZware_Nobel slicer not found
Suggestion:
Reinstall XYZware_Nobel.
● Error Code 1022: Transmission failed
Suggestion:
Make sure the USB wire is securely connected to the printer. Do not remove the wire before data transmission is completed.
● Error Code 1023: Insufficient memory to load file(s)
Suggestion:
Increase system memory to 4G RAM and 1G graphics RAM or above. Leave some prints for next task if you are printing several models. For better performance, it is
recommended to run the program on 64-bit operating system.
● Error Code 1024: XYZware_Nobel runtime error
Suggestion:
Restart XYZware_Nobel.
● Error Code 1025: Unable to save the file
Suggestion:
Please check if there is enough space on the selected disk/device. Delete some files and try again. If you are saving the file to external device, make sure that the device
is securely connected.
● Error Code 1026: Non-manifold issue is found in the file
Suggestion:
Repair the file with 3D model repairing software (such as netfabb or MakePrintable) and slice the model with XYZware_Nobel again.
● Error Code 2001: Resin bottle not found
Suggestion:
Make sure resin bottle is placed correctly and NFC tag is in place under the bottle. If the NFC label is missing, please contact customer service center.
● Error Code 2003: Resin bottle empty
Suggestion:
Resin bottle is empty is based on the the reading from the NFC tag. Select "INFO">"RESIN STATUS" to check resin level. When "REMAINING" is shown as "0%", then the
resin bottle should be empty. Please install another XYZprinting resin bottle before printing.
-21-