Setting; Automatic Horizontal Calibration; Buzzer; Restore Default - XYZ Printing Da Vinci nano Quick Manual

Software Functional Descriptions
Interface Introduction
Manually adjust the movement of X/Y/Z
Axis for printer maintenance.
Note
Jog Mode
Please follow the on-screen
instructions.
Print bed calibration may be
implemented before the printing
process.
Calibrate
Move the extruder module to the
lower left corner of the printing
area. Please refer to the calibrate
instructions provided by the
software.

Automatic horizontal calibration

Automatic horizontal calibration
may either be ON or OFF.
Default: ON.
The software would automatically
Others
implement horizontal calibration
and compensation accordingly.
Printing speed will be improved if
automatic horizontal calibration
has been switched to OFF.
However, this may affect printing
quality.
Please upgrade the latest
firmware version for the best
printing quality of the printer.
FW upgrade
1. First click on Home Axes.
The extruder module will be
returned to the initial axis
position.
2. You may manually enter
the adjustment value:
Range: 1 to 150; step: 1 mm

Setting

Z-Offset function will help you to
adjust the printing distance between
the print bed and extruder module.
Each adjustment has a step of 0.05
mm.
Z-Offset

Buzzer

Buzzer may either be ON
or OFF. Default: ON.
When the buzzer is
turned on, the printer will
output an audible signal
when a button is pressed,
receiving data, print job
is finished, or issue is
detected.
Info
Move extruder module
rightwards and leftwards.
Move extruder module
forwards and backwards.
Move the print axis (Z-AXIS)
upwards and downwards.

Restore Default

Click Restore Default
to reset to default
setting.
Information related to printer
setting.
8