Table of Contents
Advertisement
Chapter 4 Award BIOS Setup
SUPER IO DEVICE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
X ECP Mode Use DMA
PWRON After PWR-Fail
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. ONBOARD SERIAL PORT 1/2
Select an address and corresponding interrupt for the first and second
serial ports.
2. ONBOARD PARALLEL PORT
This item allows you to determine access onboard parallel port
controller with which I/O address.
3. PARALLEL PORT MODE
Select an operating mode for the onboard parallel (printer) port.
Select Normal, Compatible, or SPP unless you are certain your
hardware and software both support one of the other available modes.
4. ECP MODE USE DMA
Select a DMA channel for the parallel port for use during ECP mode.
5. PWRON AFTER PWR-FAIL
This item allows you to select if you want to power on the system after
power failure. The choice:Off,On,Former-Sts.
Page: 4-14
Phoenix – Award CMOS Setup Utility
SuperIO Device
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
[On]
F6:Fail-Safe Defaults
Item Help
Menu Level ►
F7:Optimized Defaults
PSB-701LF USER
'
S MANUAL
Advertisement
Table of Contents
