Monitoring Enhanced Object Tracking - Cisco 3032 Software Configuration Manual

Monitoring Enhanced Object Tracking

This example shows how to configure and display IP SLAs state tracking:
Switch(config)# track 2 200 state
Switch(config)# end
Switch# show track 2
Track 2
Response Time Reporter 1 state
State is Down
Latest operation return code: over threshold
Latest RTT (millisecs) 4
Tracked by:
This example output shows whether a route is reachable:
Switch(config)# track 3 500 reachability
Switch(config)# end
Switch# show track 3
Track 3
Response Time Reporter 1 reachability
Reachability is Up
Latest operation return code: over threshold
Latest RTT (millisecs) 4
Tracked by:
Monitoring Enhanced Object Tracking
Use the privileged EXEC or user EXEC commands in
information.
Table 42-1
Command
show track [object-number]
show track brief
show track interface [brief]
show track ip [object-number] [brief] route
show track resolution
show track timers
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
42-10
1 change, last change 00:00:47
HSRP Ethernet0/1 3
1 change, last change 00:00:47
HSRP Ethernet0/1 3
Commands for Displaying Tracking Information
Chapter 42 Configuring Enhanced Object Tracking
Table 42-1 to display enhanced object tracking
Purpose
Display information about the all tracking lists or
the specified list.
Display a single line of tracking information
output.
Display information about tracked interface
objects.
Display information about tracked IP-route
objects.
Display the resolution of tracked parameters.
Display tracked polling interval timers.
OL-12247-04