Pim Versions - Cisco 3032 Software Configuration Manual

Understanding Cisco's Implementation of IP Multicast Routing
PIM is defined in RFC 2362, Protocol-Independent Multicast-Sparse Mode (PIM-SM): Protocol
Specification. PIM is defined in these Internet Engineering Task Force (IETF) Internet drafts:
•
•
•
•
•

PIM Versions

PIMv2 includes these improvements over PIMv1:
•
•
•
•
•
•
•
PIM Modes
PIM can operate in dense mode (DM), sparse mode (SM), or in sparse-dense mode (PIM DM-SM),
which handles both sparse groups and dense groups at the same time.
PIM DM
PIM DM builds source-based multicast distribution trees. In dense mode, a PIM DM router or multilayer
switch assumes that all other routers or multilayer switches forward multicast packets for a group. If a
PIM DM device receives a multicast packet and has no directly connected members or PIM neighbors
present, a prune message is sent back to the source to stop unwanted multicast traffic. Subsequent
multicast packets are not flooded to this router or switch on this pruned branch because branches without
receivers are pruned from the distribution tree, leaving only branches that contain receivers.
When a new receiver on a previously pruned branch of the tree joins a multicast group, the PIM DM
device detects the new receiver and immediately sends a graft message up the distribution tree toward
the source. When the upstream PIM DM device receives the graft message, it immediately puts the
interface on which the graft was received into the forwarding state so that the multicast traffic begins
flowing to the receiver.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
44-4
Protocol Independent Multicast (PIM): Motivation and Architecture
Protocol Independent Multicast (PIM), Dense Mode Protocol Specification
Protocol Independent Multicast (PIM), Sparse Mode Protocol Specification
draft-ietf-idmr-igmp-v2-06.txt, Internet Group Management Protocol, Version 2
draft-ietf-pim-v2-dm-03.txt, PIM Version 2 Dense Mode
A single, active rendezvous point (RP) exists per multicast group, with multiple backup RPs. This
single RP compares to multiple active RPs for the same group in PIMv1.
A bootstrap router (BSR) provides a fault-tolerant, automated RP discovery and distribution
mechanism that enables routers and multilayer switches to dynamically learn the group-to-RP
mappings.
Sparse mode and dense mode are properties of a group, as opposed to an interface. We strongly
recommend sparse-dense mode, as opposed to either sparse mode or dense mode only.
PIM join and prune messages have more flexible encoding for multiple address families.
A more flexible hello packet format replaces the query packet to encode current and future
capability options.
Register messages to an RP specify whether they are sent by a border router or a designated router.
PIM packets are no longer inside IGMP packets; they are standalone packets.
Chapter 44 Configuring IP Multicast Routing
OL-12247-04