Creating Or Modifying An Ethernet Vlan - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Configuring Normal-Range VLANs

Creating or Modifying an Ethernet VLAN

Each Ethernet VLAN in the VLAN database has a unique, 4-digit ID that can be a number from 1 to
1001. VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs. To create a normal-range
VLAN to be added to the VLAN database, assign a number and name to the VLAN.
When the switch is in VTP transparent mode, you can assign VLAN IDs greater than 1006, but they are
Note
not added to the VLAN database. See the
page
For the list of default parameters that are assigned when you add a VLAN, see the
Normal-Range VLANs" section on page
Beginning in privileged EXEC mode, follow these steps to use config-vlan mode to create or modify an
Ethernet VLAN:
Command
Step 1 configure terminal
Step 2
vlan vlan-id
Step 3 name vlan-name
Step 4 mtu mtu-size
Step 5 remote-span
Step 6
end
Step 7
show vlan {name vlan-name | id vlan-id} Verify your entries.
Step 8 copy running-config startup config
To return the VLAN name to the default settings, use the no name, no mtu, or no remote-span
config-vlan commands.
This example shows how to use config-vlan mode to create Ethernet VLAN 20, name it test20, and add
it to the VLAN database:
Switch# configure terminal
Switch(config)# vlan 20
Switch(config-vlan)# name test20
Switch(config-vlan)# end
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
10-8
10-11.
Purpose
Enter global configuration mode.
Enter a VLAN ID, and enter config-vlan mode. Enter a new VLAN ID
to create a VLAN, or enter an existing VLAN ID to modify that VLAN.
Note
(Optional) Enter a name for the VLAN. If no name is entered for the
VLAN, the default is to append the vlan-id with leading zeros to the
word VLAN. For example, VLAN0004 is a default VLAN name for
VLAN 4.
(Optional) Change the MTU size (or other VLAN characteristic).
(Optional) Configure the VLAN as the RSPAN VLAN for a remote
SPAN session. For more information on remote SPAN, see
"Configuring SPAN and RSPAN."
Return to privileged EXEC mode.
(Optional) If the switch is in VTP transparent mode, the VLAN
configuration is saved in the running configuration file as well as in the
VLAN database. This saves the configuration in the switch startup
configuration file.
"Configuring Extended-Range VLANs" section on
10-4.
The available VLAN ID range for this command is 1 to 4094.
For information about adding VLAN IDs greater than 1005
(extended-range VLANs), see the
Extended-Range VLANs" section on page
Chapter 10 Configuring VLANs
"Configuring
"Configuring
10-11.
Chapter 22,
OL-8915-01