Switch On Phase - Vega VEGABAR 66 Operating Instructions Manual

Switch on phase

VEGABAR 66 • 4 ... 20 mA/HART
5.8 Switch on phase
After connecting VEGABAR 66 to power supply or after a voltage
recurrence, the instrument carries out a self-check for approx. 30
seconds:
Internal check of the electronics
l
Indication of the instrument type, the firmware as well as the
l
sensor TAGs (sensor designation)
Output signal jumps briefly (approx. 10 seconds) to the set fault
l
current
Then the corresponding current is outputted to the cable (the value
corresponds to the actual level as well as the settings already carried
out, e.g. factory setting).
5 Connecting to power supply
33