Vega VEGABAR 66 Operating Instructions Manual page 42

6 Set up with the indicating and adjustment module PLICSCOM
Carry out position cor-
rection
42
Basic adjustment
▶
Display
Diagnostics
Service
Info
Confirm the menu "Basic adjustment" with [OK], the menu item
2
"Unit" will be displayed.
Unit
Unit of measurement
bar ▼
Temperature unit
°C
▼
Activate the selection with [OK] and select "Units of measure-
3
ment with [->].
Activate the selection with [OK] and select the requested unit with
4
[->] (in the example mbar).
Confirm with [OK] and move to position correction with [->].
5
The adjustment unit is hence switched over from bar to mbar.
Proceed as follows to select the temperature unit:
à Activate the selection with [OK] and select "Temperature unit
with [->].
à Activate the selection with [OK] and select the requested unit with
[->] (e.g. °F).
à Confirm with [OK].
The temperature unit is hence switched over from °C to °F.
Proceed as follows:
Activate in the menu item "Position correction" the selection with
1
[OK].
Position correction
Offset
=
P
+0000 mbar
53 mbar
Select with [->], e.g. to accept actual measured value.
2
Position correction
Accept current measured
value?
▶ Accept
Edit
Confirm with [OK] and move to min.(zero) adjustment with [->].
3
Selection options: °C, °F.
6)
6)
VEGABAR 66 • 4 ... 20 mA/HART