Table of Contents
Advertisement
Endstop
M3*8mm Screw
M3 Washer
Step 1. Assemble the driving wheel carriage.
a. Insert 2 linear bearings into the grooves of the driving wheel carriage.
b. Insert the endstop into the driving wheel carriage. Note the direction of the
endstop.
c. Fix the pulley on the stepper motor shaft, with the threaded part up.
d. Fix the motor to the driving wheel carriage with 4xM3*8mm screws and 4
washers (with the connector downwards).
1
NO. 40
4
NO. 15
4
NO. 5
32
Advertisement
Table of Contents
Need help?
Do you have a question about the Duplicator 5 and is the answer not in the manual?
Questions and answers