Submenu Lmnet (Master): Configuration Of Modules - Lauda RP 845 Operating Instructions Manual

LMnet
7.6.3 Submenu
Module/component-specific possible settings are only shown, when the hardware is connected.
Configure modules
LMnet
38
(Master): Configuration of modules
°C
RDC--
B/LM
Configure refrig. system
B/<P-
Configure analog module
@lA--
Conf. RS232/485 module
pR---
Config. digital module
c0&--
Dlc
Proline Low-temperature Thermostats
Protection system
°C
Activate Command
°C
°C
°C
°C
°C
End
°C
Starting up
Protection system version,
characteristics and settings
of protection system.
⇒ Section 7.6.9
Indicates, that a Command
Console is connected.
Only shown on thermostats,
with a refrigerating system.
The compressor may be
switched from automatic
Bm @ to manual
Bm < / Bm 0 mode.
⇒ Section 7.6.10.
Only shown, if an analogue
module is present.
⇒ Section 8.4.
Only shown, if an RS232/485
module is present.
⇒ Section 8.3.
Only shown if a digital
module is present.
⇒ Section 8.5
YACE0072 / 21.08.07