Configured; Re-Establishing Connectivity-Method 1; Re-Establishing Connectivity To The Cisco Smart Call Home Server When Ipv6 Is Configured - Cisco CSR 1000v Series Software Configuration Manual

Re-establishing Connectivity to the Cisco Smart Call Home Server when IPv6 is Configured

Command or Action
Step 8
license smart register idtoken id-token
Example:
Router# license smart register idtoken YjBkOWM5YTItMDFiOS00Z
jBmLTllY2YtODEzMzg1YTMyZDVhLTEzODE0MjE0%0ANzc5NDF8U1B
DUTAySWFRTmJqa1NnbmlzRUIyaGlYU053L0pHZTNvUW9VTFpE%0AekxCOD0%3D%0A
The system will now contact the Cisco Smart Licensing servers to obtain
authorization for Smart Licensing
What to Do Next
Go to
Re-establishing Connectivity to the Cisco Smart Call Home
Server when IPv6 is Configured
This section describes what to do if there is a failure to connect to the Cisco Smart Call Home Server when
IPv6 is configured, as mentioned previously in
To re-establish connectivity with the Cisco Smart Call Home Server, use one of the following two methods,
depending on the version of Cisco IOS XE that you are using:
If you are using one of the following recent versions of Cisco IOS XE: 3.16.6, Denali 16.3.4 and later, Everest
16.4.2 and later, Everest 16.5.1 and later, see
If you are using one of the following versions of Cisco IOS XE: 3.16.5 (or earlier), Everest 16.4.1, Denali
16.3.1 to 16.3.3, see
Note that in some cases, after configuring the previous steps, you may need to restart the Cisco CSR 1000v
to fully re-establish connectivity.
Re-establishing Connectivity—Method 1
This method applies to the following Cisco IOS XE releases: Cisco IOS XE 3.16.6, Cisco IOS XE Denali
16.3.4 and later, Everest 16.4.2 and later, and Everest 16.5.1 and later.
If there is an IPv6 address on an interface and the device cannot connect to the Internet or Smart software
agent, configure the interface to only use IPv4 for smart licensing, with the following configuration mode
command:
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
178
Requesting Cisco Smart License Throughput Level Licenses, on page 180
Re-establishing Connectivity—Method 2, on page
Purpose
Registers the device instance with the Cisco licensing cloud.
to be performed once per device instance.
The license agent registers the product with Cisco and recei
certificate. This certificate is saved and automatically used
communications with Cisco. The license agent automatical
registration information with Cisco every 30 days.
Enabling Cisco Smart Licensing, on page
Re-establishing Connectivity—Method 1, on page
179.
Installing Cisco CSR 1000v Licenses
174.
178.