Disabling Remote Management By The Cisco Prime Network Services Controller Host - Cisco CSR 1000v Series Software Configuration Manual

Configuring Support for Remote Management by the Cisco Prime Network Services Controller
Disabling Remote Management by the Cisco Prime Network
Services Controller Host
SUMMARY STEPS
1. enable
2. configure terminal
3. remote-management
4. no pnsc host ipv4-addr local-port number shared-secret string
5. end
6. show remote-management status
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3 remote-management
Example:
Router(config)# remote-management
Step 4 no pnsc host ipv4-addr local-port number shared-secret
string
Example:
Router(cfg-remote-mgmt)# no pnsc host
172.25.29.234 local-port 8443 shared-secret
********
Step 5
end
Example:
Router(cfg-remote-mgmt)# end

Disabling Remote Management by the Cisco Prime Network Services Controller Host

Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enters remote-management configuration mode.
Disables remote management by Cisco Prime Network
Services Controller.
When remote management by Cisco Prime
Note
Network Services Controller is disabled using this
command, the REST API PUT, POST and
DELETE operations are enabled.
Exits configuration mode and enters privileged EXEC
mode.
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
295