Telrad BreezeCOMPACT 1000 System Manual page 83

Chapter 3 - Operation and AdministrationBS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.7.2.6.3.3.4 Service Flow Data Delivery Type
The Service Flow Type for data delivery services: ugs, rtvr, nrtvr, be, ertvr or any.
A change in the Service Flow Data Delivery Type takes effect after the next reset.
3.7.2.6.3.3.5 Service Flow Traffic Priority
The priority of Service Flow traffic. The value can be 0–7 or ANY (255).
A change in the Service Flow Traffic Priority takes effect after the next reset.
3.7.2.6.3.3.6 Service Flow Media Flow Type
The Service Flow Media Flow Type, as defined in the ASN-GW or AAA server. This is an optional parameter (depending on
the value configured for Enable Service Flow Media Flow Type below). Its value can be up to 32 characters.
A change in the Service Flow Media Flow Type takes effect after the next reset.
3.7.2.6.3.3.7 Enable Service Flow Media Flow Type
Indicates whether the condition for the Service Flow Media Flow Type is enabled or disabled. If true, the Service Flow
Media Flow Type is considered when looking for a match.
A change in the Enable Service Flow Media Flow Type takes effect after the next reset.
3.7.2.6.3.3.8 Outer DSCP Marking
The DSCP value to be used for marking the outer IP header (IP/GRE). The range is 0–63.
A change in the Outer DSCP Marking takes effect after the next reset.
3.7.2.6.3.3.9 802.1p Priority Marking
The 802.1p priority to be used for marking traffic. The range is 0–7.
A change in the 802.1p Priority Marking takes effect after the next reset.
3.7.2.6.4 ASN-GW Load Balancing
At the BTS level, up to two pools (with different priorities), each with up to 10 ASN-GWs, can be defined (see
Load Balancing Pools" on page
the Default Authenticator is automatically added to the Primary Pool that is the higher priority pool (even though it is not
shown as belonging to the pool).
At the BS level, you can enable/disable the use of each of the two pools. The Secondary Pool can be enabled only if the
Primary Pool is enabled and includes at least one entry. Note that if both pools are disabled, or if the enabled pool(s) is/are
empty, the ASN-GW load-balancing feature is disabled and only the Default Authenticator is used.
The ASN-GW Load Balancing menu includes the following options:

Pools Availability

Primary Pool

Secondary Pool
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
58). The BS inherits these pools. It should be noted that the ASN-GW defined in the BS as
BS Menu
"ASN-GW
84