Telrad BreezeCOMPACT 1000 System Manual page 78

Chapter 3 - Operation and AdministrationBS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.7.2.4.1 Target Ni
The target noise and interference level for the PUSC zone, in dBm.
The range is from -130 to -110 in steps of 1 (dBm). The default is -127.
3.7.2.4.2 Required C/N Levels
Available only in the Show manu. Specifies the required CINR value for different MCSs and feedback zone massages.
3.7.2.4.3 Allowed Interference Level
This parameter defines the correction of maximum allowed UL SINR based on measured DL SINR.
The options are Very High, High, Medium and Low.
The default is High.
A change in the Allowed Interference Level takes effect after the next reset.
3.7.2.5 Feedback
The Feedback menu enables you to view/update the values configured for the following parameters:

IR CDMA Allocations Period

Start of Ranging Codes Used

Maximum Cell Radius

Ducting Mitigation Mode
3.7.2.5.1 IR CDMA Allocations Period
The period of IR CDMA allocations (Initial Ranging Interval), in frames.
The available options are 1, 2, 4, 6, 8 and 10. The default is 2.
A change in the IR CDMA Allocations Period takes effect after the next reset.
3.7.2.5.2 Start of Ranging Codes Used
The starting number of the group of codes used for the uplink.
The available options are 0, 64, 128 and 192. The default is 0.
A change in the Start of Ranging Codes Used takes effect after the next reset.
3.7.2.5.3 Maximum Cell Radius
The maximum cell radius, in km.
The available values are 1, 2, 4, 8, 15, 23 and 30. The default is 2.
A change in the Maximum Cell Radius takes effect after the next reset.
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
BS Menu
79