Telrad BreezeCOMPACT 1000 System Manual page 53

Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Local Management IP Address

Local Management Subnet Mask
Note that the permitted value range for certain parameters may depend on the value configured (or to be configured) for the
BS Bearer IP Address (see
Changes in IP Interfaces parameters take effect after the next reset.
3.5.2.2.1 Bearer Subnet Mask
The subnet mask used with the BS Bearer IP Address.
The default is 255.255.255.0.
A change in Bearer Subnet Mask takes effect after the next reset.
3.5.2.2.2 Bearer Next Hop Gateway
The IP address of the Default Gateway for bearer traffic.
The Bearer Next Hop Gateway must be within the range defined by the BS Bearer IP Address and Bearer Subnet Mask.
The default is 0.0.0.0 (must be changed to a valid value if the IP addresses of core network equipment are not within the
range defined by BS Bearer IP Address and Bearer Subnet Mask).
A change in the Bearer Next Hop Gateway takes effect after the next reset.
3.5.2.2.3 Bearer VLAN ID
The VLAN ID to be used with bearer traffic.
Valid values are 11–100 and 110–4094.
The default is 11.
A change in the Bearer VLAN ID takes effect after the next reset.
3.5.2.2.4 Sector 1 – Default Authenticator IP
The IP address of the default authenticator ASN-GW for Sector 1.
The default is 0.0.0.0 (must be changed to a valid value).
A change in the Default Authenticator takes effect after the next reset.
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
"IP Address" on page 82).
BTS Menu
54