Chapter 3 - Operation and AdministrationBS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.7.1.4
Name
An optional descriptive parameter. A string of up to 32 characters. The default is null.
3.7.1.5
Cell ID
The Cell ID (IDCell) used for preamble selection. The range is from 0 to 31.
3.7.1.6
Segment Number
The segment (BS) number in a three sector BS (0–2).
3.7.1.7
Preamble Index
Read-only. The Preamble Index used by the BS (0–113).
3.7.1.8
Frame Number Offset
Controls the offset applied between the internal frame count and the reported frame number. The available options are Zero
and Random. If Random is selected, the device chooses a random number between 0 to 15. The default is zero (0).
A change in the Frame Number Offset takes effect after the next reset.
3.7.1.9
Total Uplink Duration
The total duration of the uplink in a frame, in slots (one slot equals 3 symbols).
To avoid BS-BS interference, the Total Uplink Duration must be identical in all BSs in the same geographical region.
The range is 4–7 for a BS bandwidth of 5 or 10 MHz and 3–5 for a BS bandwidth of 7 MHz.
3.7.1.10
Paging Group ID
The Paging Group ID of the BS.
The range is from 0 to 65535. 0 means that Idle Mode is not enabled. If Idle Mode is enabled (Paging Group ID is not 0), the
value should be unique in the Radio Access Network (different Paging Group ID for each BS). Idle Mode should be either
enabled in all units in the network (Paging Group ID other than 0) or disabled in all units (Paging Group ID = 0). A
combination in the same Radio Access Network of units with Paging Group ID of 0 (Idle Mode disabled) and units with
Paging Group ID other than 0 (Idle Mode enabled) should be avoided.
BreezeCOMPACT System Manual
BreezeCOMPACT System Manual
BS Menu
69