Table 17: First Zone Minimum Size Recommended Value Range - Telrad BreezeCOMPACT 1000 System Manual

Chapter 3 - Operation and AdministrationBS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The available options are 2, 4,....34 (2xN, where N=1-17) or -1 for No Limitation. The default is -1 (No Limitation).
The Maximum Size cannot be lower than the Minimum Size.
A change in the Maximum Size takes effect after the next reset.
Table 17 describes the recommended values for the First Zone Minimum Size and Maximum Size:.

Table 17: First Zone Minimum Size Recommended Value Range

BS Bandwidth (MHz)
For First Zone Maximum Size, the values are as follows:

If the First Zone Minimum Size is set to No Limitations, the value range for the Maximum Size is the same as for the
Minimum Size.

Otherwise, the value range is No Limitations or the First Zone Minimum Size+2N, up to a maximum of Y, as defined
below.
The value of Y (which is actually the number of slots available for DL data) that sets the upper limit for the Minimum and
Maximum Size parameters depends on the Maximum Cell Radius and the Total Uplink Duration parameters, using the
following formula:
Y=A-3*(Total Uplink Duration)-(Extra TTG),
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
Basic Map Repetition
7/10
5 MHz
Minimum Size (Symbols) (Up to a Maximum of Y, as
Defined Below)
6 No Limitation or 8+2N
4 No Limitation or 6+2N
2 No Limitation or 4+2N
1 No Limitation or 4+2N
6 N/A
4 No Limitation or 8+2N
2 No Limitation or 6+2N
1 No Limitation or 4+2N
BS Menu
75