Telrad BreezeCOMPACT 1000 System Manual page 54

Breezecompact series base stations
Table of Contents

Advertisement

Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.5.2.2.5
Sector 2 – Default Authenticator IP
The IP address of the default authenticator ASN-GW for Sector 2.
The default is 0.0.0.0 (must be changed to a valid value).
A change in the Default Authenticator takes effect after the next reset.
3.5.2.2.6
External Management IP Address
The IP address of the External Management interface. The value must be unique in the managed network.
The default is 192.168.1.1.
In Unified Connectivity Mode, the External Management IP Address should be within the address range defined by BS
Bearer IP Address and Bearer Subnet Mask.
A change in the External Management IP Address takes effect after the next reset.
3.5.2.2.7
External Management Subnet Mask
The subnet mask of the External Management interface.
The default is 255.255.255.0.
In Unified Connectivity Mode, the External Management Subnet Mask should be configured to the same value as the Bearer
Subnet Mask.
A change in the External Management IP Address takes effect after the next reset.
3.5.2.2.8
External Management Next Hop Gateway
The IP address of the Default Gateway for external management traffic.
The External Management Next Hop Gateway must be within the range defined by External Management IP Address and
External Management Subnet Mask.
The default is 192.168.1.1 (an IP address 0.0.0.0 is a valid value if the IP address of external management equipment is
within the range defined by External Management IP Address and External Management Subnet Mask).
In Unified Connectivity Mode, the External Management Next Hop Gateway should be configured to the same value as the
Bearer Next Hop Gateway.
A change in the External Management Next Hop Gateway takes effect after the next reset.
3.5.2.2.9
External Management VLAN ID
The VLAN ID to be used with external management traffic.
Valid values are 11–100, and 110–4094.
The default is 12.
BreezeCOMPACT System Manual
BreezeCOMPACT System Manual
BTS Menu
55

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Telrad BreezeCOMPACT 1000

This manual is also suitable for:

Breezecompact 2000Breezecompact 3000

Table of Contents