Connectivity - Telrad BreezeCOMPACT 1000 System Manual

Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.5.1.4 Contact Person
An optional descriptive parameter. A string of up to 32 printable characters.
The default is null (an empty string).
3.5.1.5 Legacy ASN-GW Mode
The Legacy ASN-GW Mode defines functionality supported by the external ASN-GW.
Select enable if using a Cisco ASN GW (supports only IP CS services). The BS should support only an IPv4 CS type. This
means that the BS should verify whether this type is received from the CPE within the registration request and if so, include
it in the attachment request towards the ASN-GW. All other CS types supported by the CPE and received in the registration
request are ignored and not forwarded to the ASN-GW.
Select disable if using any other approved ASN GW. The BS should support the following CS types: IPv4, Ethernet, VLAN,
IPv4-over-Ethernet and Pv4-over-VLAN. This means that it should verify whether these types are received from the CPE
within the registration request and if so, include them in the attachment request towards the ASN-GW. All other CS types
supported by the CPE and received in the registration request are ignored and not forwarded to the ASN-GW.
The default is disable.
A change in Legacy ASN-GW Mode takes effect after the next reset.
3.5.2

Connectivity

The Connectivity submenu includes the following options:

IP Interfaces

L1 & L2

ASN-GW Load Balancing Pools

QoS Marking Rules
3.5.2.1 Management and IP Interfaces
The system uses different IP domains for the following traffic types:

Bearer IP domain for subscriber data and ASN/CSN control traffic

External Management domain for remote management traffic

Local Management domain for local (direct) management traffic
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
BTS Menu
52