Chapter 2: Commissioning; Introduction; Breezecompact Installation - Telrad BreezeCOMPACT 1000 System Manual

Chapter 2 - CommissioningIntroduction

Chapter 2: Commissioning

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.1

Introduction

After completing the installation process, some basic unit's parameters must be configured locally using the Monitor
program in order to enable discovery by the Element Management System and remote management of the unit.
Refer to "Monitor Program" on page 46
It is recommended to reset the unit to its factory default values before proceeding with following configuration steps:
Enter the Monitor program and select BTS > Unit Control > ShutDown Operation > Update > resettoFactoryDefault.
You will be prompted to confirm the requested action.
2.2

BreezeCOMPACT Installation

For detailed installation instructions, refer to the BreezeCompact Quick Installation Guide.
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
for information about accessing the Monitor program using Telnet and how to use it.
Introduction
35