Telrad BreezeCOMPACT 1000 System Manual page 81

Breezecompact series base stations
Table of Contents

Advertisement

Chapter 3 - Operation and AdministrationBS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ASN-GW Load Balancing
3.7.2.6.1
Bearer Interface
The Bearer Interface menu enables you to view/update the values configured for the following parameters:
IP Address
Default Gateway Connectivity Status
3.7.2.6.1.1
IP Address
The IP address of the bearer interface of the BS. Must be unique in the network.
A change in the Bearer IP Address takes effect after the next reset.
3.7.2.6.1.2
Default Gateway Connectivity Status
Read-only. The status of connectivity with the default authenticator: unknown, up or down. The keep-alive mechanism starts
only after first registration at the ASN-GW. Until then, this mechanism is disabled and the connectivity status is unknown.
3.7.2.6.2
Authentication
The Authentication menu enables you to view/update the values configured for the parameter described below.
3.7.2.6.2.1
Threshold - Active MSs
The threshold for the number of MSs in active operation state (not Idle) served by the BS. Exceeding this threshold sets the
alarm Excessive MS number.
The range is 0–512. When set to 0, the alarm is disabled. The default is 512.
3.7.2.6.3
QOS Marking Rules
The QoS Marking Rules menu includes the following options:
Internal ASN Traffic QOS Rules
Internal Management Traffic QOS Rules
QOS Rules
3.7.2.6.3.1
Internal ASN Traffic QOS Rules
The Internal ASN Traffic QOS Rules menu enables you to view/update the values configured for the following
parameters:
Intra ASN DSCP
802.1p Priority
3.7.2.6.3.1.1
Intra ASN DSCP
DSCP priority value to be used for marking of intra-ASN (R8/R6) traffic. The range is 0–63. The default is 0.
A change in the Diffserve Code Point takes effect after the next reset.
3.7.2.6.3.1.2
802.1p Priority
802.1p priority value to be used for marking of intra-ASN (R8/R6) traffic. The range is 0–7. The default is 0.
BreezeCOMPACT System Manual
BreezeCOMPACT System Manual
BS Menu
82

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Telrad BreezeCOMPACT 1000

This manual is also suitable for:

Breezecompact 2000Breezecompact 3000

Table of Contents