Telrad BreezeCOMPACT 1000 System Manual page 5

Legal Rights
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To comply with Industry Canada exposure requirements, and FCC RF exposure requirements in Section 1.1307 and 2.1091
of the FCC Rules, the antenna used for this transmitter must be fixed-mounted on outdoor permanent structures with a
separation distance of at least 390 cm from all persons.
Pour se conformer aux exigences d'exposition d'Industrie Canada, et aux exigences FCC dans les sections 1,1307 et 2,1091
de la réglementation FCC, l'antenne utilisée pour cet émetteur doit être montée d'une manière fixe sur des structures
permanentes de plein air avec une distance de séparation d'au moins 390 cm de toutes personnes.
Industry Canada Statement
Users can obtain Canadian information on RF exposure and compliance from the Canadian Representative:
Nick Dewar
Nick.Dewar@Telrad.com
Canadian Radio Standards Specifications (RSS) Compliance Statement
This device has been designed to operate with the antennas listed in
18 dBi. Antennas not included in this list or having a gain greater than 18 dBi are strictly prohibited for High-density areas
of use with this device. Low-density areas can use a higher-gain Antenna.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the Equivalent
Isotropically Radiated Power (EIRP) is not more than that permitted for successful communication.
R&TTE Compliance Statement
This equipment complies with the appropriate essential requirements of Article 3 of the R&TTE Directive 1999/5/EC.
Safety Considerations – General
For the following safety considerations, "Instrument" means the BreezeCOMPACT units' components and their cables.
Grounding
The BTS chassis is required to be bonded to protective grounding using the bonding stud or screw provided with each unit.
Safety Considerations – DC-powered Equipment
CAUTION
Risk of electric shock and energy hazard.
Restricted Access Area: The DC-powered equipment
should only be installed in a Restricted Access Area.
Installation Codes: The equipment must be installed
according to the latest edition of the country's national
electrical codes. For North America, equipment must be
installed in accordance with the US National Electrical
Code and the Canadian Electrical Code.
Overcurrent Protection: A readily accessible Listed
branch circuit overcurrent protective device, rated 10A,
must be incorporated in the building wiring.
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
"Antennas" on page 28, and having a maximum gain of
ATTENTION
Risque de décharge électrique et d'electrocution.
Zone d'Accès Limité: L'alimentation en courant continue
doit être installée dans une zone a accès limité
Normes d'installation: les équipements doivent être
installes d'après les dernières normes en vigueur. Pour
l'Amérique du nord les équipements doivent être installés
d'après les normes électriques nationales US et les normes
électriques Canadiennes.
Protection de surintensité: Une protection de surintensité
de 10A doit être installée sur le circuit d'alimentation.
5