Telrad BreezeCOMPACT 1000 System Manual page 56

Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3: Operation and Administration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CAUTION
The L1 & L2 option enables you to select any of the applicable ports in order to view or update the following parameters:

Operational State

Port Negotiation Mode

Port Speed

Duplex Mode

Actual Duplex Mode: Read-only. The actual duplex mode of the port (none if the port is down)

Actual Speed: Read-only. The actual speed of the port (0 if the port is down)
3.5.2.3.1 Operational State
The Operational State parameter applies only for the Show menu. It indicates the current operational status of the port (Up or
Down).
3.5.2.3.2 Port Negotiation Mode
The mode for negotiating the port speed and the duplex mode with the link partner (Auto or Manual).
The Port Speed and Duplex Mode parameters are configurable only if the Port Negotiation Mode is Manual.
The default for all ports is Auto.
For Data Port 1, if the Operational State is Up, the Negotiation Mode is forced to Auto.
3.5.2.3.3 Port Speed
The port speed to be used for the physical interface.
Applies only if the Port Negotiation Mode is set to Manual.
For Data Port 1 (if applicable), only 1,000 Mbps (1 Gigabit) is supported.
For Data Port 2, the valid values are 10, 100 or 1000 Mbps and the default is 1,000 Mbps (1 Gigabit).
For Data Port 3, the valid values are 10 or 100 Mbps and the default is 10 Mbps.
3.5.2.3.4 Duplex Mode
The duplex mode for the interface (Full Duplex or Half Duplex).
Applies only if the Port Negotiation Mode is set to Manual.
The default for all ports is Full-Duplex.
BreezeCOMPACT System Manual BreezeCOMPACT System Manual
If you want to switch from Data Port 1 to Data Port 2 (or vice versa), the unit must be reset (or powered
down and then powered up) after physically connecting to the new port.
BTS Menu
57