Fitting The Frames & Dress Guard - Rinnai Symmetry RDV3611 Installation Manual

Fitting the frames & dress guard
Before fitting the frames and/or dress guard, ensure the glass front is secured in place.
It is critical when fitting the glass front that you double check that it is not scratched or
WARNING
damaged in any way, and that you have checked the gasket.
Inner frame
Hook over the glass and secure
in place on the two large lower
magnets on the front assembly.
Outer frame
Screw into position with the four
screws provided. If you have the
granite outer frame, refer to the
separate installation instructions
provided with the frame.
Mesh dress guard (optional
accessory)
This inserts flush into the inner
frame by hooking onto the top
and then pushing in—no fixings
required.
Commissioning
Complete the installation and commissioning checklist in the customer operation guide, and
make sure you leave the guide with the customer. Explain to the customer about the use and
care of the unit, and that they understand the instructions and operation of the appliance.
If operating without a dress guard, advise the customer of the safety instructions to prevent
the risk of injury.
Mesh dress guard Inner frame
RDV3611 Installation Manual: 11156-A 01-12 | 25
Outer frame