Table of Contents
Advertisement
Log set installation
The log set is packaged separately and consists of five log pieces and three moulded rocks. Use
extreme care when handling the log pieces, they are made from fragile material and will damage
easily.
Use these instructions in conjunction with the log location guide, which is attached to the
engine. Experience has shown that the majority of performance problems have been
caused by the log set being installed incorrectly.
IMPORTANT
6
It is important to place the pieces in the correct position. Incorrect placement can create carbon
build-up and affect performance. Malfunctioning due to incorrect log/rock placement is not covered
by warranty. The unit MUST NEVER be used with broken logs or rocks or other burn media.
1. Carefully remove the log set from
the packaging and fit the front
base left log (with moulded rock).
There is a cutout in the back
of the log and in the burner—it
should only fit one way, sitting flat
with no movement.
2. Fit the snake shaped log into the
curve on the far right of the burner
base. It should sit hard up against
the burner and once positioned
not rock or wobble.
5
3
1
4
2
1
Symmetry RDV3611 installation guide 11156-H 08-21 | 15
6
2
Advertisement
Table of Contents
