Choke And Throttle Rods (Ms 200 T); The Handle Housing - Stihl MS 200 Service Manual

1
: Turn the throttle rod (1) slightly
and disconnect it from the lever
on the carburetor (arrow).
– Remove the throttle rod (1).
2
1
– Pry the switch shaft (1) out of its
mount.
: Disconnect the choke rod (2)
from the choke lever (arrow) first,
then from the carburetor.
– Check the choke and throttle rods
and replace if necessary.
1
: Attach choke rod (1) to lever
(arrow) on choke shaft first.
MS 200, MS 200 T
1
2
: Attach choke rod (1) to choke
lever.
– Push the switch shaft (2) into its
mount until it snaps into position.
The choke rod must be in the guide
(arrow).
1
– Attach throttle rod (1) to lever (2)
on throttle shaft.
: Place the throttle rod (1) in the
guides (arrows) and push it over
the edge of the handle.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
– Check operation.
12.3.2 Choke and Throttle Rods
(MS 200 T)
Color-coding of rods and levers:
Choke: lever white, rod silver-
colored
Throttle: lever orange, rod copper-
colored
1
3
– Remove the control lever and
handle molding, b 12.1.2
2
: Pull out the link (1).
– Carefully pull out the long throttle
rod (2) and choke rod (3).
The throttle trigger and interlock
lever may pop out.
: Pull the double choke lever (1)
out of the handle housing and
choke rod.
2
1
79