Stihl MS 200 Service Manual page 68

1
: Place anchor loop (1) in the
opening (arrow) in the installing
tool (2) 1116 893 4800 – the
anchor loop must point inwards.
Make sure the anchor loop does not
project too far. It cannot be pushed
back after it is fitted in the installing
tool – but it can be pulled out.
Distance from end of anchor loop to
edge of spring housing
a = 20 mm.
: Fit the rewind spring
counterclockwise in the tool.
– Hold the spring windings so that
they cannot pop out.
MS 200, MS 200 T
2
1
– Push the installing tool (1) with
spring on to the starter post.
Line up the installing tool so that the
anchor loop (2) is above the lug (3)
and the opening in the installing tool
is in the position shown (arrow).
: Use a suitable tool to engage the
anchor loop (2) on the lug (3) –
pull out the loop a little if
necessary.
: Apply tool to openings (arrows) to
push the spring into its seat in the
fan housing.
2
3
: Press the installing tool against
the spring and rotate it slightly
clockwise until the spring is
properly seated.
– Remove the installing tool.
1
Check that the rewind spring (1) is
properly seated and the anchor loop
engages the lug (arrow).
67