Stihl MS 200 Service Manual page 112

: Take out the screws (arrows).
– Remove screw (1) from
handlebar.
1
– Lift the handle housing slightly.
: Pull out the fuel hose (1) between
the handle and tank housings
(arrow).
1
: Pry the fuel hose (1) out of its
seat (arrow).
– Pull the fuel hose (1) out of the
tank housing, check it and
replace if necessary.
.
MS 200, MS 200 T
: Push the fuel hose (1) through
the hole (arrow) in the fuel tank.
1
: Line up the fuel hose (1) – the
flange must match the contour of
the hole (arrow).
– Coat the grommet on the fuel
hose with STIHL Press Fluid,
b 16
– Push the fuel hose into the hole
until the rubber lip is properly
seated.
1
1
: Push the fuel hose (1) between
the handle and tank housings
(arrow).
1
– Position the hoses in the handle
housing.
: Push the fuel hose (1) on to the
stub (arrow).
– Install the tank vent, b 14.6.4
– Reassemble all other parts in the
reverse sequence.
111