Cylinder - Stihl MS 200 Service Manual

2
1
: Use press sleeve (1)
1129 893 2400 to install the oil
seal (2).
The seating face must be flat and
free from burrs.
– Wait about one minute, then
rotate the crankshaft several
times.
– Reassemble all other parts in the
reverse sequence.
8.4

Cylinder

Before removing the piston, decide
whether or not the crankshaft has to
be removed as well.
Cylinder installed
To remove the flywheel and clutch,
the.crankshaft has to be blocked by
inserting the locking strip in the
spark plug hole.
Cylinder removed
To remove the flywheel and clutch,
the crankshaft has to be blocked by
resting the piston on the wooden
assembly block.
– Remove the chain sprocket
cover, bar and chain, b 5
– Pull off the boot and unscrew the
spark plug, b 6
MS 200, MS 200 T
– Remove the muffler, b 8.1
– Remove the fan housing,
b 10.2
– Remove the carburetor,
MS 200 b 14.2
MS 200 T b 14.2.1
– Remove the handle housing,
MS 200 b 12.4
MS 200 T b 12.5
– Drain the fuel and oil tanks, b 1
– Remove the tank housing,
b 14.8
1
: Pull the impulse hose (1) off the
nipple (arrow).
: Take out the four cylinder base
screws through the holes
(arrows) in the cylinder.
: Carefully lift the cylinder (1) away.
: Remove the cylinder gasket (1).
– Inspect and clean the sealing
face (arrow), b 16
The sealing face must be in perfect
condition. Always replace
components with damaged sealing
faces, b 4.7.
Always use a new cylinder gasket
when re-installing the cylinder.
1
1
33