Version With Multi-Part; Removing And Installing The Tank Housing - Stihl MS 200 Service Manual

1
: Use hook 5910 893 8800 to
remove the fuel hose (1) from the
fuel tank.
Do not overstretch the fuel hose.
– Fit the pickup body, b 14.7.1
– Close the tank cap.
14.7.5 Fuel hose
(MS 200 T)

Version with multi-part

tank vent system
In the previous tank vent system the
tank vent is fitted separately in the
tank housing. A single fuel hose is
used.
The tank vent does not need to be
removed.
The procedure for removing and
installing the fuel hose is the same
as for the new tank vent system,
b 14.7.4
112
14.8 Removing and Installing
the Tank Housing
If a mounting thread for plastic
tapping screws is damaged, the
tank housing can be repaired by
fitting a thread insert.
– Drain the fuel tank, b 1
– Remove the muffler, b 8.1
– Remove the handle housing,
MS 200, b 12.4
MS 200 T, b 12.5
: Take out the screws (arrows).
– Turn the machine over.
: Take out the screws (arrows).
: Turn the tank housing (1) slightly
and lift it over the intake manifold.
– Pull the tank housing (1) out of
the impulse hose.
– Inspect the tank housing (1) and
replace if necessary
Only transfer those parts from the
old tank housing that are not
included with the replacement – see
parts list.
: Pry out the stop buffer (1).
– Check the stop buffer (1) and
replace if necessary.
– Coat the stop buffer (1) with
STIHL Press Fluid, b 16
– Reassemble in the reverse
sequence.
MS 200, MS 200 T
1
1