Removing And Installing The Handle Housing (Ms 200) - Stihl MS 200 Service Manual

2 1
– Line up the long throttle rod (1) –
the curved end (2) must be one
the double throttle lever.
: Carefully push the long throttle
rod (1) into the double throttle
lever and throttle trigger (arrows).
The double throttle throttle lever
may fall out or the interlock lever
and throttle trigger may pop out.
1
– Check all rods – the levers must
be seated in the guides and rods
attached to the levers.
: Push the link (1) into the holes
(arrows) as far as stop.
– Fit the handle molding and switch
lever, b 12.1.2
– Tightening torques, b 3.5
– Check operation.
MS 200, MS 200 T
12.4 Removing and Installing
the Handle Housing
(MS 200)
– Remove the carburetor, b 14.2
– Remove the tank vent, b 14.6.2
– not necessary on versions with
"tank vent installed in tank
housing".
– Remove annular buffer from the
oil tank, b 11.2
: Disconnect wiring harness (1)
from the short circuit wire
connector (2).
: Take out the screws (arrows).
– Remove screw from handlebar.
2
: Remove the sleeve (1) and
washer (2).
2
1
1
: Lift the handle frame (1) and push
out the manifold (arrow).
1
81